| FT-2.2/FT-2.2WR/FT-2.2P |
| Description: |
| Single 15" active, bi-amp only, coaxial, full-range loudspeaker system with 2" exit compression driver. The FT-2.2 is recommended where maximum SPL and reliability are required. The Time Offset Correction and equalization fro the FT-2.2 are achieved by using the PAS TOC™ S2 processor which also contains limiters, four-pole linear phase dividing filters and subwoofer circuits. |
|
|
| Features: |
| • |
Cast frame concentric 15" loudspeaker component with 4" voice coil |
| • |
2"exit high frequency compression driver |
| • |
Baltic birch enclosure construction |
| • |
Foam backed steel grille |
| • |
Recessed handles |
| • |
Integral Pole Cup |
| • |
Dual /parallel Neutrik NL4 Speakon™ input connectors |
| • |
Compact, arrayable enclosure design to facilitate installation or set up |
|
|
| FT-2.2WR |
| Same as above with weather resistant components: |
| • |
TourTuff all-weather polyuretane finish |
| • |
Water Resistant Grille Liners |
| • |
Treated Speaker Cones |
|
|
| FT-2.2P |
| Powered version includeds amplifier and DSP functions |
|
| Amplifier Features: |
| • |
Selectable Mains Input: 115/230 Vac |
| • |
Thermal & Overcurrent protection |
| • |
H.F. Protection |
| • |
Quiesent (idle) power: less than 16 watts (Both channels) |
| • |
EMI conforms to EN55103-1 and EN55103-2 (European Union Electromagnetic interference standard) |
| • |
Neutrik "PowerCon" AC connector |
|
|
| DSP Features: |
| • |
Transformer isolated input (NC3FP connector) |
| • |
24 bit/96kHz A to D and D to A conversion |
| • |
Signal present, Clip and Protection indicators |
| • |
24 dB/oct Linear Phase dividing filters |
| • |
Time Offset Correction™ (TOC™) and equalization |
|
|
| Finish Options and Handles |
